22 January 2016

Cut of Diamonds

Cut of Diamonds

Cutting a diamond-shaped (such as round, oval, pear, etc.) but it’s not a diamond rates means that the symmetry and polish. The beauty of a diamond depends on other factors more cuts even more. Brightness (the combination of all the white light reflections from the surface and created a polished diamond Interior gloss), fire (into the light dispersion: extremely difficult, though there are three basic effects the appearance of diamond cutting, analysis and measure for color flashes appear to be seen as the color of the spectrum,) and radiation (diamond or a light source is moved to sparkle, a light and dark or flashes).

Cut of Diamonds

Cut of diamonds in the rough stone fashion (as much as possible to preserve carat weight diamond cutting up rough stone) maximum efficiency against optimum cutting (and hence display) must balance. Many customers are a little smaller, fine-cut diamond to a larger, more fair-cutting cut diamond is willing to pay, there’s pressure on the cutter to sacrifice weight view. This Cut note this is why it is so important; He was cut Badly in an effort to win Fair carat weight it gives to the buyer to determine the stones.

At the time, left (blue) the same rough stone give two potential a diamond:

Very deep cut of diamonds (orange) very big profit investments is part of a larger Diamond cutter diamond earnings, she went into labor. Smaller, less in total than the great good he can sell diamonds diamond (white), but due to a price per-carat rough stone just superior to the appearance, but also will command a higher yield because of the reduction in (which is why diamonds are more expensive to build).

Diamond Cutting Rates

Every facet of the diamond size, shape, and proportion of the diamond angle refers to the relationship between. A wide range of combinations, but all in all it is possible that specifies the interaction of light with the diamond.

Light strikes cut of diamonds time, approximately 20% reflects from the surface immediately (glare). The diamond, part of the 80% it enters (here, the observer can appreciate it) out through the bottom. Every facet of a well-proportioned diamonds diamond Crown (top) reflects back over to maximize the amount of light in the eye of the observer are placed and angled properly. This reflected light Flash, fire and brilliance is perceived as.

The following diagram shows the three common light patterns. When you meet any face a diamond light (facet passing bend), or reflect (bounce back) or it will break. The majority of the light is as important as the light hits the angled facet cut reflects or is the reason determines the break.

Tags: / / / /


No comments so far. Be the first!